DYNACORD´s SUB 112 is a vented, direct radiating cabinet, equipped with the high-power DYNACORD DND12S400 neodymium transducer. The conical vent system shows significantly less distortion and lower air noise at low frequencies than common circular vent openings. 

The SUB 112 contains a passive filter, 6 dB/oct., that suppresses high frequencies. Appropriate fullrange cabinets, e.g. DYNACORD’s D 8 can therefore be directly connected in parallel to the SUB 112 if an extended bass reproduction is required. You just have to connect the SUB 112 and the D 8 with a regular Speakon cable in parallel.

The SUB 112 cabinet is made of 15mm birch plywood. All corner joints and braces are grooved and glued. The cabinet´s surface is painted with a 2-K laquer finish . The acoustic foam front on a powder coated steel grille protects the DND12S400 woofer against damage during transport and bad environmental conditions. The connector panel uses two 4-pole Speakon connectors (INPUT/THRU) for a safe connection and easy daisy-chaining to other cabinets. The pin assignment is 1+/1-. Pins 2+ and 2- are also connected between the two Speakon connectors. A pole-mount flange allows easy speaker-on-a-stick applications. Please always take care that every speaker stack has been mechanically secured against accidental falling down. Please always consult a certified structural engineer for correct and safe setup methods.

The cabinet is equipped with four large rubber feet. Two handles allow easy and safe transport. A protective cover is available as an optional accessory.

Specifications

• Order No. D113134
• Cabinet Subwoofer
• Configuration Built-In Hi-Cut Filter
• Nominal impedance 8 Ohms
• Rated power RMS 400 Watts
• Program power 800 Watts
• Peak power 1600 Watts
• SPL 2,83 V / 1m 1 W / 8 Ohm 92 dB
• Max. SPL 1m (calculated with peak power) 124 dB
• Frequency range ( -10dB ) 43Hz - 350Hz
• Passive crossover frequency 124 Hz
• Component SUB DND12S400
• Order No. D366712
• Connectors SUB 1+, 1-
• Wired through 2+, 2-
• Connector model Speakon NL4MPR
• Dimensions (WxHxD) mm 545 x 380 x 445 mm
• Shipping weight 22 kg
• Net weight 20 kg
• Enclosure material Birch Plywood
• Finish 2-Component Paint Grille
• Powder coated steel, Acoustic Foam
• Handles 4
• Castors4
• Warranty 36 months