SOUNDVISION D-2650

SOUND VISTION D-2650 เพาเวอร์แอมป์ 2-channel 2x650W @8Ω Class D Digital Power Amplifier

FEATURE

1. Multifunction and 1U design

Traditional amplifier use heavy toroidal transformers and cooling tubes, inconvenient to transport and carry. D-2000 use high quality digital amplifier switching power supply, with the U.S. IR digital amplifier module, the maximum power (2X850W 8 ohm) output , just 7 kg, 1U design, lightweight , which is easy for installation orperformance using.

2. Advanced high-quality switching power supply module

Digital switching power amplifier for selection is critical , our engineers through repeated trials , the power sector is currently selected.This module anti-interference ability, high stability of output voltage, over power protection has short circuit protection, high conversion efficiency, making the digital amplifier power and stability are quite good.

3. American IR digital with japan qualified capacitance

After continuous exploration and research by our engineers use the imports main component (the U.S. IR digital power tube amplification scheme and Japan’s advanced technology bulk capacitance) so the digital amplifier power will be stronger, fast transient response signal, thereby gaining a very good sound quality.

4. Efficient and safe, green energy saving

Class AB or Class H of traditional amp, utilization is only 30% -50%, but digital amplifier switching power efficiency up to 90%, the quiescent current consumption to zero, even if work for 8 hours, the temperature is not exceeding 50 degrees,absolutely safe, reliable and environmental protection.

SPECIFICATIONS

Stereo Mode ( 2 Channels output ) Continuous average output power per channel

8Ω/FTC20HZ~20KHZ/0.1%THD

4Ω/FTC20HZ~20KHZ/0.1%THD

2Ω/FTC20HZ~20KHZ/0.1%THD 650W

1050W

1350W

S/N ( 20HZ~20KHZ) 8Ω >95dB

Distortion(@8Ω 1KHZ) <0.15%

Sensitivity of input 1.0V

Frequency response 20HZ~20KHZ+/-0.5dB

Circuit design CLASS D

Damping coefficient >600@8Ω

Cooling mode 4 fans, airflow from the back to the front

Connector(each channel) Input: XLR output: lock pin type jack

Control panel Front panel:AC power switch,single channel 1/2 gain adjust.Back panel: Stereo /Parallel / Bridge mode selection

Indicator light Power:Green LED ,Signal:Yellow LED ,CLIP:Red LED ,Protect:Red LED

Protect funtion Short circuit, over heat, automatic limit,long-term output, DC / AC protection

Size(Wide x deep x high) 483mmx343mmx45mm

Weight 7KG

AC input 220V